4 Installation
4.1 Placement of thermostat
1,3–1,5 m
SD0000002
•
Select an indoor wall and a position 1,3 m to 1,5 m above the
floor.
•
Ensure that the thermostat is away from direct sunlight.
•
Ensure that the thermostat will not be heated through the wall by
sunshine.
•
Ensure that the thermostat is away from any source of heat, for
example television set, electronic equipment, fireplace,
spotlights, and so on.
•
Ensure that the thermostat is away from any source of humidity
and water splashes (IP30).
4.2 Installation procedure
Warning!
The thermostat uses 230 V AC power. Never open
and/or separate the front cover from the rear face of the
thermostat!
Caution!
Do not push hard on the LCD screen as this may cause
irreparable damage.
SI0000464
To install the thermostat, follow these steps:
Remove the back plastic cover
1
SI0000456
≤ 4 mm
Use a flat screw driver/tool (width max. 4 mm) to remove the back
plastic cover.
If necessary: cut the back part plastic
2
SI0000457
If the thermostat is wall mounted and the cables (or some of them)
are placed on the wall, cut the back part plastic.
Remove the breakouts
SI0000458
3
OPTION
Wall mounting with 2 screws
: Remove the 2 breakouts for the
screws in the back cover.
Option ― wall mounting with 1 screw
: Remove the breakout of the
center hole in the back cover.
6
|
Uponor Base thermostat display T-27 230V
|
Installation and operation manual
