P a g e
| 6
Manuel Fuel Feeding, ÜKY/W Hot Water Boiler User Manual
exceeded. In order to minimize the water missing in the installation, the water level should be checked
regularly and the leaks in the system should be removed. Because excessive water additions to the
system will cause lime accumulation on the water side of the boiler and this will cause regional
overheating and this will damage the boiler.
The boiler must not be burned directly, it must be installed on a level surface. It is recommended that
the height of the base on which the boiler is to be installed shall be at least 10 cm and its width is wider
than the outside dimensions of the boiler. Thanks to the base, the boiler is protected from the water
that can accumulate on the ground.
The fire should not be approached when the lid of the burning boiler is open;
Do not add water when the boiler is hot.
ELECTRICAL INSTALLATION INSTRUCTIONS
There is no electrical connection in wood type boilers. If the heating installation is built upwards, it can
be used without a pump. In general, the circulation pump is used because the installation pipes are
various up and down. Since there is no control panel in ÜKY / W type boilers, the operation of the
pump depends on the user.
If a direct power plug will be used for the pump, plug in the pump when the boiler
temperature is 40°C.
Make sure that there is no adverse situation such as deformation in the pump plug and aging
in the insulation.
