Univex SRM12, Руководство по запчастям и обслуживанию

Страница: 29 / 41

SPEED CONTROL ASSEMBLY
(Figure 12)
DISASSEMBLY:
1.
WARING:
DISCONNECT THE ELECTRICAL POWER SUPPLY CORD.
2. Remove the mixer top cover (Figure 14 [9]) per section 2, mechanics maintenance “REMOVAL
OF TOP COVER” instructions on page 2.4.
3. Remove the rear access panel (Figure 14 [11]).
4. Remove the retaining ring (Figure 12 [13]. Remove the rod end and rod assembly [12] from the
cam assembly [10]. Loosen the set screws [9] in the cam assembly.
5. Drive the roll pin [21] from the speed control lever assembly and remove the lever assembly and
washer [4].
6. Remove the nuts and washers [6 & 7] holding the speed control housing [5] to the mixer housing
and remove the speed control assembly.
7. Pull the cam assembly [10] from the speed control housing.
8. Remove the two screws [14] and remove the detent disk [16].
REASSEMBLY:
9. Reassemble the speed control in the reverse of the above procedure. Grease the cam assembly
shaft and detent disk during assembly with MolyKote BR2 Plus or general purpose bearing
grease. Adjust the belt as described in the Mechanics Maintenance section2 on page 2.1.
10. If the speed control handle moves while the mixer is running, tighten the set screws [9] until the
movement stops.
Page 6.1
Roll Pin
Speed Control Handle Assembly
Retaining Ring
Rod End
Detent Disk
Set Screws
Speed Control Housing