background image

Page 16

GAS

BLUE LED

AUDIBLE & VISUAL SIGNALS

HORN

OPERATIONAL SUMMARY

CONDITION / RECOMMENDATION

Silent

Off

Off

Condition:

 AC power is present. DC power is present.

Recommendation:

 None

CO

RED LED

Silent

Off

Off

Condition:

 Alarm is powered by battery backup. AC Power

is not  present.

Recommendation:

 Check the breaker or fuse box for power.

If the breaker or fuse box looks normal, call a licensed
electrician for assistance.

3 beeps,

2 second pause,

3 beeps,

6 second pause,

4 beeps,

5 second pause,

1 beep

Blinks On in

sync with

the 1 beep

Blinks On in sync

with the cycle of

4 beeps and

turns off

Condition:

 The test/silence button has been pressed. The

test sequence lasts for approx. 20 seconds.

Recommendation:

 None

Off

Off

Condition:

 One or more units are not responding to

interconnected alarm.

Recommendation:

 Turn off AC power at the circuit breaker

or fuse box and disconnect the alarm from the mounting
bracket and make sure the connector plug is securely
attached on units that did not alarm. If still no alarm, have
a licensed electrician check to see if yellow wire is
connected properly.

Horn does not

sound when

other alarms

are active

or when

interconnected

alarm’s

test/reset

button is

pressed

3 Beeps,

2 second pause,

repeat

Off

Off

Condition:

 Originating Smoke Alarm.

Recommendation:

 If hazard is identified, take all

precautions if an alarm sounds by calling an Emergency
Service and getting out of the home.

3 Beeps,

2 second pause,

repeat

Off

Off

Condition:

 Non-originating Smoke Alarm.

Recommendation:

 Another interconnected smoke alarm

has sensed smoke, causing all interconnected units to
sound. If hazard is identified, take all precautions if an alarm
sounds by calling an Emergency Service and getting out of
the home.

4 Beeps,

5 second pause,

repeat

Off

Blinks On in

sync with

4 beeps

Condition:

 Originating CO Alarm.

Recommendation:

 If hazard is identified, take all

precautions if an alarm sounds by calling an Emergency
Service and getting out of the home.

4 Beeps,

5 second pause,

repeat

Off

Off

Condition:

 Non-originating CO Alarm.

Recommendation:

 An interconnected CO alarm has

sensed CO, causing all interconnected units to sound. If
hazard is identified, take all precautions if an alarm sounds
by calling an Emergency Service and getting out of the
home.

1 Beep,

2 second pause,

repeat

Off

Blinks On

in sync

with the

1 beep

Condition:

 Originating GAS Alarm.

Recommendation:

 If hazard is identified, take all

precautions if an alarm sounds by calling an Emergency
Service and getting out of the home.

1 Beep,

2 second pause,

repeat

Off

Off

Condition:

 Non-originating GAS Alarm.

Recommendation:

 An interconnected GAS alarm has

sensed GAS, causing all interconnected units to sound. If
hazard is identified, take all precautions if an alarm sounds
by calling an Emergency Service and getting out of the
home.

3 Beeps,

2 second pause,

repeat

Off

Off or Blinks

On in

sync with

the 1 beep

Condition:

 Nuisance Alarm.

Recommendation:

 If there is no hazard present, verify the

alarm imounted in the correct location (see User’s Manual).
Reset alarm as instructed below.

Horn sounds

when no

hazard is

present

Off

Off or Blinks

On in sync

with 4 beeps

Condition:

 Smoke alarm when cause of alarm is known

and poses no threat.

Recommendation:

 The smoke alarm Silence Feature can be

activated by pressing and releasing the Test/Silence button on
the initiating alarm while in alarm condition. Silence mode will last
for approx. 8-12 minutes (with the red LED blinking on approx.
every 10 seconds).

4 Beeps,

5 second pause,

repeat

Blinks

On in sync

with 4 beeps

Off

Condition:

 CO alarm when cause of alarm is known and

poses no threat.

Recommendation:

 The CO alarm Silence Feature can be

activated by pressing and releasing the Test/CO Silence button
on the initiating alarm while in alarm condition. The alarm will
remain silent for approx. 5 minutes (with the red LED blinking
on approx. every 10 seconds), depending on the level of CO
detected. If CO levels drop below alarm levels, the alarm will
remain silent and return to normal operation. If CO levels
remain constant or increase, this indicates a potentially dangerous
situation and the horn will sound again. Ventilate area.

SMOKE

RED LED

Off

Off

Blinks on during

the cycle of

3 beeps and

turns off

Off

Blinks approx.

once every

second

Off

Off

Off

Off

Off

Blinks approx.

once every

second

Off or Blinks

approx. once

every 20 seconds

Off

POWER

GREEN LED

On and Blinks

Off approx

every 20
seconds

Off and Blinks

On approx

every 40
seconds

Turns off
when the

3 beeps start

*See below

Turns off
when the

3 beeps start

Turns off
when the

4 beeps start

Turns off
when the

3 beeps start

Turns off
when the

4 beeps start

Turns off
when the

1 beep starts

Turns off
when the

1 beep starts

Turns Off when

the 3 beeps

start

Turns off
when the

beeps start

Turns off
when the

4 beeps start

Содержание MICN102



















Отзывы: