37
23. Remove the defeat tool.
24. Remove the power cord.
25. Replace top enclosure.
4.7
DOOR HIGE ADJUSTMET
OTE:
Top door hinges should be set just tight enough to hold the door in the vertical
position.
1.
Hold door in vertical position and tighten hinge screws with Phillips screwdriver so door
just stays up. Moving the door one inch to either side should cause the door to drop.
2.
Close door and ensure it is flat against top cover. If hinges are too tight, the door will bow
by the hinges. Check front and back of door and loosen the hinges, if necessary, so door
stays flat.
CAUTIO:
Excessive bow in door may affect the safety of the system.
3.
Set front door hinges loose so door will lay flat against frame when closed. If hinges are
too tight, the door sides will bow just above the hinges.
4.8
BELT ADJUSTMET AD REPLACEMET
1.
Ensure that the power cord is removed.
2.
Remove top Enclosure:
a.
To remove the top cover, unclasp the four latches that hold the top cover down. Two
latches can be found on the right side of the machine and two can be found on the left
side of the machine.
b.
Ensure power cord is removed then gently lift the cover up and off of the machine.
This will require two people to accomplish. Watch out for one inch mirror in the
front left corner of the machine and the electronics and water lines on the right side of
the machine.
4.8.1 X AXIS BELT REPLACEMET
1.
Loosen the two screws on each X axis pulley holder and remove pulley holder (reference
Figures 2 and 3).
