CHAPTER 4: CONTROLS
MODEL HF2 2 kHz HIGH FREQUENCY RESISTANCE WELDING POWER SUPPLY
990-057
4-3
HF2 Weld Control - Rear Panel Inputs and Outputs
Figure 4-2. HF2 Weld Control Rear Panel
•
POWER - Refer to
Chapter 2, Power Line Voltage, Current, and Wire Size Requirements,
for
complete instructions on how to properly apply power to the HF2 Weld Control.
•
FUSES F1, F2 - Refer to
Chapter 2, Power Line Fuse Requirements
for complete
specifications for Power Line Fuse sizes.
•
SENSING PORT
The Sensing Port contains both input and output lines for communicating to the HF2 Weld
Transformer and the MA-600 Multiple Weld Head Selection Box. The connector attached to
the end of the Sensing Port Cable is a 16 pin Honda, P/N: MC16LSF, (Unitek P/N: 250-235).
This connector mates with the connector on the HF2 Weld Transformer.
