CHAPTER 2: GENERAL SETUP
MODEL HF2 2 kHz HIGH FREQUENCY RESISTANCE WELDING POWER SUPPLY
990-057
2-5
HF2 Weld Transformer to Weld Head Connections (Figure 2-6)
1
Connect the Upper Weld Cable to the
Positive Terminal on the HF2 Weld
Transformer.
2
Connect the Lower Weld Cable to the
Negative Terminal on the HF2 Weld
Transformer.
3
Attach the Voltage Sensing Cable
connector to the HF2 Weld Transformer
INPUT connector.
4
Attach each lead at the opposite end of
the Voltage Sensing Cable to each
Electrode Holder. Note: Polarity is not
important.
Figure 2-6. HF2 Weld Transformer to
Weld Head Connections
5
Strain relief each Voltage Sensing lead to its corresponding Electrode Holder so that the lead
will not break or move under heavy production operating conditions.
6
Do
not
attach the Firing Switch Cable at this time. This procedure is covered in
Chapter 3
.
Weld Sentry Option
A small tag displaying the message WELD SENTRY INSTALLED will be attached to the front panel of
the HF2 Weld Control if the optional Weld Sentry Module has been installed. Refer to the separate
Weld Sentry User's Manual, 990-291 for Weld Sentry operation.
The Built-in Weld Sentry Module can be added to the HF2 Weld Control after purchase by ordering the
HF2 Weld Sentry Module, P/N 3-130-01-01.
Help Screen Languages
Integrated circuit chip U2 on the Main printed circuit board varies in memory capacity according to the
help screen languages available. Refer to
Appendix D
for special jumpering instructions relative to the
installation of IC chip U2.
