United Technologies Interlogix Advisor Advanced ATS1000A-SM, Руководство для менеджеров

Страница: 12 / 100

4 Advisor Advanced Manager Manual
• Blinking: An alarm has occurred in the area while the area was unset (LED
flashes slow), or an alarm has occurred in the area while the area was set
(LED flashes fast).
Programmable LEDs
The programmable LEDs 1 and 2 can be configured in two ways:

Different areas are indicated.
An area can be assigned to LED 1 or LED 2. A LED is green when all
assigned areas are ready to set. The status of a LED can be:
- Green: All areas assigned are ready to set.
- Red: Any area is set or part set.
- Blinking green: Entry or exit time is started.
- Blinking red: An alarm has occurred in an area while unset (a LED flashes
slow), or an alarm has occurred in an area while set (a LED flashes fast).

One area is indicated.
Both LEDs show a single area state. The status of the LEDs can be:
- Both green: The area is ready to set.
- Both red: The area is set or part set.
- LED 1 red, LED 2 off: The area is in part set 1.
- LED 1 off, LED 2 red: The area is in part set 2.
System alarm LEDs (available on some arming stations only)
The system alarm LEDs indicate a breach of security. One of the system alarm
LEDs flashes when an alarm has occurred (the area’s set LED also flashes to
indicate the location of the alarm). Alarm LEDs operate as follows:
• Unset alarm: Flashes when an alarm has occurred in an occupied area, and
the area was unset.
• 24-hour alarm: Flashes when an alarm has occurred in an area where a zone
has been programmed for 24-hour alarm.
• Set alarm: Flashes when an alarm has occurred in a set area.
• Tamper alarm: Flashes when an alarm has occurred due to tamper.
System faults (available on some arming stations only)
System faults are displayed on the arming station keypads if the arming station
has an LCD fitted and/or has “System faults” LEDs. Fault LEDs operate as
follows:
• Comms fail: When there is a failure in the communications between the
Advisor Advanced control panel and a central station.
• Keypad fail: When a keypad is offline.
• Expander fail: When a remote expander is offline.