4
© 2023 United States Stove Company
ASSEMBLY INSTRUCTIONS
TOOLS AND MATERIALS
You will need the following items for installation:
• A drill phillips head screwdriver.
• A ratchet wrench with a 7/16” and 1/2” sockets or
wrenches to install flue collar and leg assembly to the
unit.
• An 1/8” drill bit to drill pilot holes into the vent pipe for
securing each section.
• A non-combustible floor protector as specified in this
manual.
• All chimney and chimney connector components for
your particular chimney installation.
• Additional items for Mobile home/transportable
buildings may be needed. See “For use in Mobile home/
transportable buildings” section of this manual.
LEG INSTALLATION
Carefully lay the heater on its back and install all four legs
with the hardware provided. Note: To prevent scratching
lay cardboard down before placing the heater on its back.
50FAK AIR INTAKE
Attach the 50FAK air intake using the hardware provided.
BLOWER ASSEMBLY (INCLUDED)
The blower assembly must be disconnected from
the source of electrical supply before attempting the
installation. The blower assembly is intended for use only
with a stove that is marked to indicate such use. Do not
route the supply cord near or across hot surfaces! Fix the
assembly to the back of the stove with the four screws
provided. To install:
FOR CUSTOMER SERVICE CALL: 800-750-2723 EXT 5050
