United States Stove Company Economy Series, Руководство пользователя

Страница: 24 / 28

-85%/88AEˆˆA9%
2 2
).-D(''-.((3&(''(.)>9.9('((3' /."-2()-)3() (3
&#"
&#
& 0 Remove the control board. On the back, there is one fuse. If
it appears to be bad, replace it with a 5 Amp 125 Volt fuse.
Plug the stove back in and try to run the unit.
= / Wait for the stove to cool for about 30-45 minutes. It should
A Š
locate the high limit thermodisc. To test if the thermodisc is
80
thermodisc.
3. Bad auger motor. Remove the auger motor from the auger shaft and try to run
A ! -
thing. If the motor will not turn, the motor is bad.
, #! Start by emptying the hopper. Then remove the auger motor
by removing the auger pin. Remove the auger shaft inspec-
tion plate in the hopper so that you see the auger shaft.
Gently lift the auger shaft straight up so that the end of the
auger shaft comes up out of the bottom auger bushing.
Next, remove the two nuts that hold the top auger biscuit in.
Then rotate the bottom end of the auger shaft up towards
you until you can lift the shaft out of the stove. After you
Y
or broken welds. Remove any foreign material that might
! #
of damage such as burrs, rough spots, or grooves cut into
!
4. Loose wire or connector Check all wires and connectors that connect to the auger
motor, high limit switch, and the Molex connector.
5. Bad control board If the fuse is good, the wires and connectors check out
going to the auger motor. If there is not a full current going
to the auger motor when the fuel feed light is on, you have
a bad control board.
All manuals and user guides at all-guides.com