User Configerable Settings
17
User Settings (‘PL1’) Explained
Heater Mode (‘HEAT’)
The topside is set by default to operate in ‘Standard’ heating mode. This
means that when the temperature of the water in the spa drops below the
set temperature, the control automatically start heating, bringing Lo-Speed
of Pump-1 (or the Circulation Pump if it is set for timed/auto operation) on
as necessary.
The topside can also be set to operate in ‘Economy’ heating mode,
where the heater will only maintain the set temperature when the pump
is manually activated (if there is no 24hr Circulation Pump), and during
filtration cycles. In ‘Economy’ mode, if the current temperature falls below
the set heat temperature, the ‘Heat’ indicator light will flash to let you know
that the unit
would
be heating if not in Economy Mode.
Note:
On spas with Circulation Pumps that run 24 hours a day, economy
mode will not effect heating behavior, the control will continue to heat as
needed to maintain the set temperature, and the filtration cycle will simply
control the ozonator (if applicable).
System Time (‘CLOC’)
The second setting in the user’s configuration menu is for setting the
system time. Pressing ‘Temp Up’ will display the first setting, the Hour
Setting. The system time is reset to the default of 12 PM whenever the
units’ power is reset. Pressing ‘Temp Up’ will cycle from 12 AM (‘12:AM’)
to 11 PM (‘12:PM’). Pressing ‘Temp Down’ takes you to the second setting,
the Minutes Setting.Pressing ‘Temp Up’ will cycle from ‘--:00’ thru ‘--:59’.
