T8-S Initial Configuration
13
Changing The T8-S Topside’s Configuration Codes
Once you have entered the programming
mode, you will have Code 1 and its selected
Option showing on the display. This is shown
on the display as ‘C-O’, where C is the current
Code, and O is the currently selected/enabled
Option for that code. While in programming
mode the same 10 second time-out applies, if
you take longer then 10 seconds to change a
code’s selected option or cycle through to the next code, all settings will be
saved and the topside will time-out and resume normal operation.
Conflicting Codes
You may notice, when programming the topside that certain codes may
not be visible/selectable. This means you have another code set to an
option that conflicts with the missing option. So if you program the topside
to use the Jets-2 button to operate a two-speed Pump-2, you will no longer
see the code option allowing an air blower or third pump to be used on the
Jets-3 button (since those functions all use the same relay).
Saving Configuration Menu Changes
When the settings in the configuration menu have been properly set for
the spa’s configuration, press the ‘Aux’ button (or let the menu time-out
after approximately 15 seconds) to save changes and exit back to the
normal operation display.
Upon Configuration Completion
Once the topside has been initially configured, it will not lose those settings,
regardless of whether power to the unit is shut off or not.
Code 2 - Option 1
Currently Displayed Code
Currently Selected Option
