Unitech UT-30X, Инструкция по эксплуатации

Страница: 11 / 17

@
sales@utplindia.in +91 7046223333 , 9427301436
www.utplindia.in
www
9
Continue Configuration Mode...
UT-30X
UT-100X
MULTI CHANNEL UNIVERSAL PROCESS INDICATOR
CONTROLLER/SCANNER/DATALOGGER
: Selected
YES
: Not
no
Values :
Default Value :
no
WARNING
PERSONAL INJURY :
Configuration should be performed only by personnel who are technically competent to do
so. Local Regulations regarding electrical & safety must be observed.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS INJURY.
(100-127)
(0-99)
99
27
to
to
00
00
Values start
again
Range / Values Parameter
nadd
01
NODE ADDRESS [COMMUNICATION]
Device Address for Communication
Display
Increase the no. by key, decrease by key.
Range : Values between 0001 to 0127
Default Value :
01
NOTE : Applicable if Communication Output.
Values :
Default Value :
L-on
: Active in High
H-oN
: Active in Low
L-oN
ALARM 1 HIGH ACTION TYPE
Change the type by or key.
ON
OFF PV
SV
ON
OFF PV
SV
L-ON :
H-ON :
SV-Hyst
SV+Hyst
ty12
L-on
: Baud Rate 4800
4800
: Baud Rate 9600
9600
: Baud Rate 19200
19.2k
Change value by key, or by key.
baud
9600
BAUD RATE [COMMUNICATION]
Baud Rate for Communication
Values :
Default Value :
9600
NOTE : Applicable if Communication Output.
: Even Parity
EvEn
: Odd Parity
Odd
: None Parity
none
Change value by key, or by key.
prty
none
PARITY [COMMUNICATION]
Parity check for Communication
Values :
Default Value :
none
NOTE : Applicable if Communication Output.
Default Value :
H-on
: Active in High
H-oN
: Active in Low
L-oN
Change the type by or key.
ty21
ty31
ty41
ALARM 2/3/4 HIGH ACTION TYPE
Action type High status for particular Channel
Values :
Default Value :
L-on
: Active in High
H-oN
: Active in Low
L-oN
Change the type by or key.
ty22
ty32
ty42
ALARM 2/3/4 LOW ACTION TYPE
Action type Low status for particular Channel
Values :
ded1
ded2
ded3
ded4
DEAD BAND FOR RELAY [ALL CHANNELS]
Change the type by or key.
If set as
Only one relay get operated in this
YES
parameter, relay get active on High value
and deactivate in set point - 2 value. Used for
Level & Fan control.
of-1
of-2
of-3
of-4
OFFSET FOR INPUTS [FACTORY SET VALUE]
Offset Parameter for corresponding Input
Value : Factory Set for every Input
Default Value : (As per Input)
0038
NOTE : Factory set value, don’t change.
GAIN FOR INPUTS [FACTORY SET VALUE]
Gain Parameter for corresponding Input
Value : Factory Set for every Input
Default Value : (As per Input)
0007
NOTE : Factory set value, don’t change.
Gn-1
Gn-2
Gn-3
Gn-4