The following are the available TX Control functions:
1. CW On/Off – Controls the CW State.
2. Random Data On/Off – Controls the Random Data State.
3. Inject Random Data – Sends Random Tx Data to the Transmit FIFO on the transceiver chip
while in CW operation.
4. Set Antenna and Power – Sets physical antenna and power level for Test Modes.
5. Set Freqency – Sets the Test Frequency and locks the PLL for Test Modes.
6. Manual Tx Control – Functions for Manual Tx Control
a. Enable Tx (Set All Setings) – Sets Frequency, Power Scaler, Gain Index, and Enables
Tx
b. Enable Tx – Only enables the Tx. Note other Tx settings must be set in conjunction to
see the transmitter output.
c. Disable Tx – Disables the Tx.
d. Power Scaler
Ω
Sets the power scaler.
e. Gain Index – Sets the Tx Gain to the gain code in the internal Gross Gain table.
Command
The Command menu is shown in the following figure.
The following are the available Command functions:
1. MAC Command Execute – The input is the command number.
2. EngTst Command Execute – This is essentially a regular command operation, but it allows
for easy access to configure the Sub Command and arguments for testing purposes.
22
Copyright 2012 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
