![background image](http://html1.mh-extra.com/html/unitec/mab-150/mab-150_operating-instructions-manual_3983432015.webp)
1 7
U s e
M A B 1 5 0
ENGLISH
Sw i t c h i n g t h e m a c h i n e O N/ O F F
Sw i t c h i n g o n t h e m a c h i n e
Switch on the machine with the green
button (11) of the motor switch.
NOTE
►
The machine can only be switched on
when the magnetic clamp has been
switched on.
►
Allow a severely overheated machine
to run on at idle speed for approx.
2 minutes.
►
The machine switches off
automatically in the event of a power
failure or if the magnetic clamp is
switched off.
Sw i t c h i n g o f f t h e m a c h i n e
Switch off the machine with the red
button (12) of the motor switch.
D r i l l i n g w i t h t h e m a c h i n e
D r i l l i n g w i t h c o r e d r i l l s
When drilling with core drills, proceed as
follows:
Insert the ejector pin (A) into the core
drill.
Insert the core drill with the ejector pin
as described in the section
" In s e r t i n g
t h e t o o l "
.
Place the machine at the working
location, align it and switch on the
magnetic clamps.
Switch the machine on.
Direct the core drill to the material with
the hand lever (6).
NOTE
Observe the following instructions when
drilling with core drills:
►
Drilling with core drills does not
require great force. The drilling
process is not accelerated by higher
pressure. The drill wears faster and
the machine can be overloaded.
►
Use the pump bottle for cutting
oil/drilling emulsion (C) with CS
Unitec high-performance cutting oil
supplied for the machine.
►
When working overhead, use the
ZHS 400 high-performance grease
spray. Spray the drill on the inside
and outside before drilling. In the
case of larger drill depths, repeat this
procedure.
►
Make sure that swarf is removed
regularly. With larger drilling depths,
break up the swarf.
Содержание MAB 150
