UNIS Ultra Moto VR, Руководство по эксплуатации

Страница: 91 / 99

Ultra Moto VR Manual
03/03/2020
90
10.4 The Use,Operation Notes
4.1 While using, air compressor will be placed in the level of indoor drying, cleaning,
ventilation places, specially pay attention to get away from the scope such as dust. If you
are unable to meet the requirement, you must increase the filtering.
4.2 Please check whether the gas circuit of compressor blockage, every component has
abnormal phenomena before using, then plug the power cord plug into the power outlet to
meet the requirements(the power outlet must be good grounding),the compressor's motor
will start, electromagnetic value act, shut emptying gas circuit, complete appliance start
work( close each air supply power switch).
4.3 When pressure gauges point the pressure is reached the maximum given pressure,
pressure control automatically disconnect, air compressor will stop working. When the
compressor stopped is not to the maximum pressure because of the power supply
suspension, the compressor will be worked after the tank pressure down to the lowest
pressure control point by restoring electricity.
4.4 Connect valve mouth to the using air supply equipment pipeline; open exhaust valves
can supply gas to the equipment directly. When the pressure gauge points the pressure is
down to the set minimum pressure, pressure control automatically closed, air compressor
re-start. (The value of the minimum and maximum pressure based on different models has
been setting up before the products leave factory, generally the users can't adjust the set
value by themselves.)
4.5 If user's supply voltage is on the low side, not up to the range ±10% of the standard
voltage, can not be forced lo use, otherwise it will be damage the electrical of the
1 covery 17 valve 33 stator 49 nut
2 left fan 18 valve 34 bearing 6203-2Z 50 wheel
3 left crankcase 19 valve plate 35 adjustment washer 51 bolt
4 connecting rod 20 washer 36 vibration column 52 drain cock
(26601101728)
5 piston cup 21 right fan 37 spring 53 bolt
6 binder plate 22 shaft seal 38 air filter 54 washer
7 bolt 23 bearing 690-2Z 39 elbow 55 cushion foot
8 cylinder 24 bolt 40 deflation valve
(26601101725) 56 washer
9 obturating ring 25 bolt 41 regulator
(26601101726) 57 nut
10 obturating ring 26 right crankcase 42 40 gauge 58 pipe
11 cylinder head 27 protection ring 43 50 gauge 59 actuated valve
12 bolt 28 bolt 44 connect 60 check valve
(26601101727)
13 obturating ring 29 bolt 45 pressure switch
(26601101724) 61 plug
14 connecting pipe 30spring 46 safety valve 62 capacitor
15 bolt 31 rotator 47 handle 63 capacitor cover
16 limit block 32 nut 48 tank