INSTALLATION GUIDE
PAGE
11
FLASHKIT PRO INSTALLATION
FIX RAIL CLAMP ONTO L-FOOT:
Remove
bolt from rail clamp. Place bolt through
slot in L-foot and though hole in Rail
Clamp. Partially thread holt into rail
clamp, leaving the bolt loose to accept
the rail.
Note: Rail Clamp can be installed on any
standard L-foot.
INSTALL FLASHKIT PRO FLASHING:
Add a U-shaped bead of roof sealant
to the underside of the flashing
with the open side of the U pointing
down the roof slope. Slide the
aluminum flashing underneath the
row of shingles directly up slope
from the pilot hole as shown. Align
the indicator marks on the lower end
of the flashing with the chalk lines
on the roof to center the raised hole
in the flashing over the pilot hole in
the roof. When installed correctly, the
flashing will extend under the two
courses of shingles above the pilot
hole.
INSTALL L-FOOT:
Fasten L-foot and
flashing into place by passing the
included lag bolt and pre-installed
stainless steel-backed EPDM washer
through the L-foot EPDM grommet,
and the hole in the flashing, into the
pilot hole in the roof rafter. Drive the
lag bolt down until the L-foot is held
firmly in place. The EPDM washer
should compress and expand slightly
beyond the outside edge of
the steel washer when the proper
torque is applied.
Note: FLASHKIT PRO L-FOOT can be
installed in TWO orientations.
See Page 13 for detailed view.
