INSTALLATION GUIDE
PAGE
20
HIDDEN END CLAMP
INSTALL END CLAMPS ON RAIL:
Slide the end clamp assembly on
to the rail by engaging grooves
on both sides into the top flange
of the rail.
POSITION END CLAMPS:
Slide the end clamp assembly
onto the rail until the module
return flange is cleared for
placing the module
NOTE:
To assist insertion of the clamp
into the rail, hold the twist ties
together and slide the clamp.
Place the end cap on the rail
flange for smooth gliding of the
clamp to the required position.
ENGAGE CLAMP:
While holding the module in
position and with the clamp in contact with the
flange, tighten the end clamp bolt to the required
torque.
INSTALL MODULE END CLAMPS:
The End clamp is
supplied as kit with pre assembled end cap. The
clamp should be installed on the rails prior to
installing end modules.
INSTALL FIRST MODULE:
Position first module onto rails with the clamp clear from the return flange of the module. Hold
the end cap and drag the clamp onto the return flange of the module. Once the clamp is onto
the return flange, drag the clamp till the edge of the clamp contacts the vertical wall of return
flange.
Torque End Clamp bolt to 15 ft-lbs, No anti-seize
CAUTION
Ensure bolt is not over-torqued, use low torque
setting on drill. If using an impact driver, stop
rotation as soon as impact action of driver begins.
Module
Module
Module
Module
Note: Ensure to use a drill extension or deep socket for installing the clamp bolt.
