24
Battery change
To replace batteries
When the batteries reach 2.2 V, the low bat-
tery symbol will be shown at the bottom of the
display:
You can continue to use the UniTire until the
last of the 4 ’cells’ in the battery symbol has
disappeared.
The batteries are located inside the box. Put
UniTire on the table with the rear side up.
Unscrew the two screws and remove the rear
part of the box by lifting the end with the two
screws. Here you will see a battery holder with
two standard Alkaline 1.5 V AAA batteries.
Please replace them with two new ones
of high quality.
Please properly dispose of the used
batteries.
Insert batteries with the right polarity. If you
should by accident put them in the opposite
direction, you will not hurt UniTire or the
batteries.
When assembling UniTire again, slide the rear
part into the front part and center it before
closing it.
Do not over tighten the two screws.
Cleaning
To clean the case, display, and buttons
The exterior surfaces of UniTire products are
made from solid anodized aluminum, plastic
overlay, and stainless steel.
They are designed to be easily wiped clean
with a dry, lint free cloth.
Greasy marks should be removed by light rub-
bing with a slightly damp cloth and a trace of
proprietary glass cleaner.
Do not use any other solvent or abrasive
based cleaners.
Ensure that no liquid enters the box and
that the product is completely dry before
reuse.
Maintenance
M a i n t e n a n c e
