16
Digital gauge view in Stealth mode
Three arrows means more than 100%
away, two arrows means more than 50%
away and one arrow means more than
10% away. If you are within 10% of the
target, no arrows will be shown.
Analog gauge view in Stealth mode
The analog gauge view has less information
than the digital gauge view. Here it shows
a limited area of the scale, the actual tire
(FL = Front Left) and no actual value as a
number.
The analog gauge view in Stealth mode
has the same functions as in Sequence
mode:
To start in Stealth mode, turn UniTire on by
holding the
left
button (
3
).
Measure the tire pressure in the defined se-
quence order, and save each value by pressing
the
right
button ( ).
If you want to start over with the current
sequence, press and hold the
left
button (
3
)
down until the circle shows the first tire again.
When you save the measured values
in Stealth mode, the actual values are
stored in the memory, so you will be able
to see them in Recall mode.
Use Stealth offset in pressure mode
When Stealth mode is enabled, an offset can
be added to the current pressure value in
”Pressure mode”. This is to confuse prying
competitors.
For example:
If the offset is entered as -0.20 bar (see
”STEALTH OFFSET SETUP” on page 21) and
the real pressure is 1.65 bar, the value shown
in the display is 1.45.
Pressure mode view in Stealth mode
If a stealth offset is entered in Setup mode,
the pressure value shown is not the actual
pressure value. If no pressure is applied, a
question mark is shown to avoid the stealth
offset being visible.
The values in the history list are the real
values. It is only the current pressure
value with the large digits that is af-
fected.
Operating UniTire
R e f e r e n c e
G u i d e
