Union Switch & Signal GENISYS II, Установка оборудования

Страница: 52 / 67

UNION SWITCH & SIGNAL GENISYS II System Hardware Installation
3-12 August 1999 SM-6900B Rev. 0.0
3.2.9 Configuring GENISYS II CPU Serial Communication Jumpers
The GENISYS II hardware and executive software current at the time of release of this document
REQUIRES that jumpers JMP7, JMP8, JMP10, JMP13, JMP14, JMP15, JMP16, JMP17, and
JMP18 be placed in the factory default position. Future releases of the GENISYS II hardware
and executive software may support other jumper settings. Both jumpers JMP11 and JMP12
must be set in the same position but may be set as required by the specific installation. However,
the default setting for JMP11 and JMP12 is recommended for ALL installations (see table
below).
The following table shows the function of all serial communication jumpers and their default
position:
JUMPER FUNCTION POSITION EFFECT
JMP7 Port 4 receive data input 1-2*
2-3 ENABLED
DISABLED
JMP8 Port 4 data carrier detect input 1-2*
2-3 ENABLED
DISABLED
JMP10 Port 1 synchronous transmitter clock 1-2
2-3* INPUT
OUTPUT
JMP11 Port 3 output driver low level 1-2*
2-3 RS-232
RS-423
JMP12 Port 3 output driver high level 1-2*
2-3 RS-232
RS-423
JMP13 Port 3 synchronous transmitter clock 1-2
2-3* INPUT
OUTPUT
JMP14 Port 3 synchronous transmitter clock 1-2*
2-3 OUTPUT
INPUT
JMP15 Port 4 asynchronous clock input 1-2*
2-3 INTERNAL
OFF
JMP16 Port 3 asynchronous clock or
synchronous receiver clock input 1-2*
2-3 INTERNAL
EXTERNAL
JMP17 Port 2 asynchronous clock input 1-2*
2-3 INTERNAL
OFF
JMP18 Port 1 asynchronous clock or
synchronous receiver clock input 1-2*
2-3 INTERNAL
EXTERNAL
JMP32 Route Serial Port 4 TXD to Rear Conn.
Route Maint. Port TXD to Rear Conn. 1-2*
2-3
JMP33 Route Serial Port 4 RXD to Rear Conn.
Route Maint. Port RXD to Rear Conn. 1-2*
2-3
Jumper positions marked with (*) are the factory default.