Unigas LAMTEC BT3 Series, Руководство по установке, использованию и обслуживанию

Страница: 80 / 137

32
431 ucPin2Test Pin short circuit test detected an error!Short-circuit between
pins, pull-up of input stage defective or pin is externally stuck
at 0
440 0 sIO.sIn.uiTestSignalTimeout expired
450 0 Main power relay (K2) does not switch correctly to off when
out of power.
451 ucRelay Relay does not switch correctly, when relay power is
enabled (for details see enum teRelais)
460 uiFaultParam Failure of relais power switching or readback of relay coils of
K1 or K2Param2: Bit 0 is set if readback line of K1 is
erroneous, Bit 1 is set if readback line of K2 is erroneous
461 uiFaultParam Readback status of relay K1 or K2 differs from desired
switching status, relay propably defect.Param2:Bit 0: nominal
state of K1Bit 1: nominal state of K2Bit 8: state of readback line
of K1Bit 9: state of readback line of K2
500 0 Timeout while waiting for end of write cycle
501 0 SLA+W has been transmitted; NO ACK has been received
502 0 SLA+R has been transmitted; NO ACK has been received
503 0 Data byte has been transmitted; NO ACK has been received
504 0 BUS error due to an illegal START or STOP condition
505 0 Arbitration lost in SLA+R/W or Data bytes
510 ulI2CStat Unknown/invalid state!
600 sSRCtrl.uiOffset Correction of defective triple in Safety RAM structure failed
610 (ulong32)pucDst Invalid destination address
620 (ulong32)puiDst Invalid destination address
630 (ulong32)pulDst Invalid destination address
700 0 CPU selftest failed
701 sSelftest.sMngr.eState state-event-machine failed with AC_ERR
710 sSelftest.sWD.eErrorState Watchdog selftest failed
711 sSelftest.sWD.eState Invalid default case
720 Selftest.sVM.ucTest2Perform Invalid default case
721 Selftest.sVM.eErrorState Supply voltage monitor selftest failed
722 Selftest.sVM.eState Invalid default case
730 sSelftest.sRR.eErrorState Relay release circuit selftest failed
731 sSelftest.sRR.eState Invalid default case
740 sSelftest.sRPW.eErrorState Relay PWR release circuit selftest failed
741 sSelftest.sRPW.eState Invalid default case
750 0: USR-Stack, 1: IRQ-Stack Stack overflow detected
751 0 Stackaddress is NULL-Pointer
752 0 Stackaddress is NULL-Pointer
800 sWDog.ulReleasePtrn1 Trigger release patterns are invalid!
810 eFeedIndex Invalid Feed Index
820 eTriggerCtrl Invalid Trigger Mode
830 0 No valid watchdog trigger received (frequency or duty cycle
invalid)
900 uiErrorCode Fault from LPC_API error handler
920 0 Invalid entry in iStoerResRam
930 uiMaskedFaultCode uiMaskedFaultCode out of range!
1200 0 Flame signal doesn't disappear during self-test
1210 sIFD.eTestState Invalid default case
1220 sIFD.uiClock UP is missing test impulses
1221 sIFD.uiClock Test signal duration too short
1222 sIFD.uiClock Test signal duration too short
1240 0 Detected short circuit of LDR
1250 uiADValue Circuit selftest failed, A/D value out of expected range
1260 sLDR.eTestState Invalid default case
1270 sLDR.uiClock Test interval too long
1271 sLDR.uiClock HP released test pin too late
1272 sLDR.uiClock HP released test pin too early