Changing from Tone to Pulse Dialing
Phones can communicate with the telephone network in two ways:
tone (DTMF) or pulse dialing. If you know your phone company uses
pulse dialing or the test call for line 1 did not work, follow these steps:
With the phone in standby, press
MeNu
.
Use
up
or
DoWN
to highlight
Global Setup
, then press
ok
.
When your phone prompts you to select a line, press
LINe1
.
Use
up
or
DoWN
to highlight
Dial Mode
, then press
ok
.
Highlight
Pulse
, then press
ok
. The phone sounds a confirmation
tone. Try making another test call using line 1.
If your test call on line 2 did not connect, follow the same
process, but press
LINe2
in step 3.
If you use pulse dialing and you need to send DTMF tones during a
call (if you're using an automated response system, for example),
press to temporarily switch to tone dialing. When the call ends, the
phone automatically returns to pulse dialing mode.
Set Up the Accessory Handset(s)
If your phone came packaged with accessory handsets, follow the
steps below to get your cordless handsets ready for use.
Install the battery
Unpack all handsets, battery packs, and
battery covers. If any handset has the
battery cover already attached, press in on
the notch and slide the cover down and off.
Line up
the battery pack connector with
the jack inside the handset. (The
battery connector will only fit
one way.)
Push the battery pack connector
in until it clicks into place. Tug
gently on the wires to make
sure the battery pack is securely
connected.
1.
2.
3.
4.
5.
1.
2.
3.
