Unical ELLPREX Series, Инструкция по установке, использованию и обслуживанию

Страница: 20 / 40

20
ELLPREX 2650
cable clamps (7).
F) Position the upper panels (9 and 10) and
press them against the side panels.
G) Slide the support (11) of the upper panels
under the panels 9 & 10 and rest it on the
side panels 3b & 4b.
H) Position the upper panels (12 and 13) and
press them against the side panels.
I) Remove the protective paper film from data
plate and ventilation requirement label (14) and
fit them at the top front corner of the most
accessible side panel after removal of dust
from the surface.
The data plate and label are in the
documents envelope.
Mounting sequence (Ref. fig. 26)
A) Fit the insulation blanket (1) onto the boiler
shell and secure it in to place using the
elasticated straps (2) provided, ensuring that
the metal clips grip in to the external surface
of the insulation.
Make a covenient cut in the upper part of
the insulation blanket to get easy access
to the bulb holders.
Open the combustion chamber door and fit
the front insulation (6), inserting the hinges
in the pre-cuts.
B) Locate the side panels (3a, 3b, 3c and 4a,
4b, 4c) with the lower bend inside the
bottom L profiles and hooking the upper
bend to the upper L profile.
To determine which one of the front side
panels is the left or the right ensure that
the cable clamp plates (5) are positioned
facing toward the front edge.
C) Fit the rear upper panel (6).
Fit the plastic cable clamps (7) to the upper
rear panel (6).
D) After removal of the two side screws from
the panel board rotate its cover towards the
front and insert the cables and the
capillaries of thermometer and thermostats
through the slots on its base.
Fit the panel board to front upper panel (8).
Fit the upper panel (8), complete with the
panel board to the side panels (3a & 4a).
E) Insert the thermometer and thermostat bulbs
in the bulb holders as shown in fig. 28 and
connect the mains, the burner, the pump(s)
and any ancillary equipment to the panel
board.
Close the panel board.
Guide the burner plug through the side cable
clamp plate (5) on the preferred side and
clamp the cable using the cable clamp
supplied.
Fix the side cable clamp plates (5) to the
casing side panels (3a & 4a).
Fit the cables, leaving the boiler from the
back side, with the plastic screws of the
fig. 26