Uniblitz N-CAS VINCENT ASSOCIATES VLM1, Руководство пользователя

Страница: 12 / 23

VLM1/VLM1B User Manual 12
Terminal Block Wire Installation
The following illustrates the Terminal Block Wire Installation procedure for the VLM1 or the VLM1B
(not shown):
1. Be sure wire is stripped to length as shown.
2. Push desired wire terminal actuator in using 2mm screwdriver provided (as shown)
3. Slide wire into access hole below the terminal actuator.
4. Release the terminal actuator.
5. Wire should be connected – a slight pull on the wire (with the wire remaining stable and
connected) should indicate the wire is properly connected.
6. Connect the remainder of the wires as required.
7. For shutter operation, RED wire from actuator coil must connect to Terminal #1 and BROWN
wire from actuator coil must connect to Terminal #2.
Figure 4: VLM1/VLM1B SHUTTER Wire Installation Diagram