UNI-T UTD1000 Series, Руководство по эксплуатации

Страница: 66 / 101

UTD1000 User Manual
Illustration 1 : Measuring simple signals
To observe and measure an unknown signal in the
circuit, and to quickly display and measure the signal’s
frequency and peak-to-peak value.
1. To quickly display this signal, follow the steps
below :
ķ In the probe menu, set the attenuation factor to 10X
and set the switch on the probe to 10X.
ĸ Connect the Channel A probe to the circuitry point to
be measured.
Ĺ ress [AUTO].
The Oscilloscope will carry out auto setup to optimise
waveform display. In this status, you can further adjust
the vertical and horizontal range until you get the
desired waveform display.
2.Voltage and time parameters for automatic
measurement
Your Oscilloscope can automatically measure most
display signals. To measure signal frequency and peak-
to-peak value, follow the steps below :
ķ Press [SCOPE] for the frequently used function
menu.
ĸ Press [F2] to enter the parameter measurement
menu, then press [F1] to set parameter measurement to
defined parameter.
Ĺ Press [F2] to set defined parameter to “parameter 1”.
ĺ Press [F3] to select the “frequency” parameter with
the jog dial, then press [F4] to select channel A.
Ļ Press [F2] set defined parameter to “parameter 2”.
ļ Press [F3] to select the “peak-to-peak” parameter
with the jog dial, then press [F4] to select channel A.
Chapter 3 Practical Example Illustrations