EYE XO2 USER MANUAL
9
Hardware Install
Inser
t Sensor
Step 2: Insert Sensor
After the bracket has been firmly mounted to the ceiling, you will install
the sensor bar.
The sensor bar comes with 6 black M6 15mm screws already inserted; 3
screws in the front and 3 screws in the back. Make sure all 6 screws are
about halfway into the bar and even in length.
1
Slide the sensor bar with the 6 screws up and over through the bracket
hinges. Make sure the screws are secured in the hook part of the hinges.
Once the sensor is secured in the bracket hinges, tighten the 6 screws to
the bracket.
2
The tilt of the sensor can be adjusted with the high and low M6 15mm
screws. The regular M6 15mm screws are already screwed into the
sensor. You can change this out with the M6 155 High or Low screws to
adjust the angle/ tilt.
3
M6 High 15mm
M6 Low 15mm
M6 15mm
