** You must adjust the motion sensor on the light to the
desired area before you can adjust the time and LUX settings**
This setting controls the time span of how long your security
light will remain on. The time setting will allow you to set
the time period the light will stay on. Slide the switch to
the amount of time you would like the light to stay on. (See
illustration, dials are located on the bottom side of the motion
detector).
The LUX settings controls when the light will come on; it
controls the amount of light needed to turn the light on. The
LUX setting is marked by a sun and moon. Use one of the
three predetermined settings as illustrated. To adjust the
light to come on when it is darker outside slide the switch to
“Night”; to adjust the light to come on at dusk slide the switch
to “Dusk”.To adjust the light to come on when it is lighter
outside slide the switch to the “Day”.
● Objects that change temperature rapidly,such as heating
vents and air conditioners.These heat sources could cause
false triggering.
● areas where pets or traffic may trigger the control.
● nearby large, light-colored objects reflecting light may
trigger the shut-off feature. Do not point other lights at the
sensor.
● Detection Method: PIR (Passive Infrared)
● Detection Range: Max.50ft
● Detection Angle: Up to 180°
● LED Angle: 120°
● Time Adjustment: (minimum) 5 seconds to 1, 5, 12 minutes
● Operating Voltage: 220 ~240 volts 50Hz/60Hz
● IP Rating: 54
● Warm Up: about 60 seconds
SYMPTOM
POSSIBLE CAUSE
Lights will not come on.
1. Light switch is turned off.
2. Light is loose or burned out.
3. Fuse is blown or circuit breaker is turned off.
4. Daylight turnoff is in effect (recheck after dark).
5. Incorrect circuit wiring, if this is a new installation.
6. Re-aim the sensor to cover desired area.
Lights come on in day light.
1. Light control may be installed in a relatively dark location.
Lights come on for no apparent
reason.
1. Light control may be sensing small animals or automobile traffic (re-aim sensor).
Range is set too high. (Reduce Range setting).
Lights stay on continuously.
1. A lamp is positioned too close to the sensor or pointed at nearby objects that cause
heat to trigger the sensor. (Reposition the lamp away from the sensor or nearby
objects).
2. Light control is pointed toward a heat source like an air vent, dryer vent, or brightly-
painted heat reflective surface. (Reposition sensor. Reduce Range).
Lights flash on and off.
1. Heat or light from the lamps may be turning the light control on and off.
(Reposition the lamps away from the sensor).
2. Heat being reflected from other objects may be affecting the sensor. (Reposition
sensor).
NOTE:
Sensor has a 1.5 minute warm up period
before it will det
ect motion. when fi
rst turned on,
wait 1.5 minutes.
Model no
：
E-SM-1700-180-2H / ASIN no. B07V4CBHD7
Time Setting
Avoid Aiming The Control At:
Product Specifications
Lux Settings
Motion Sensor Security Light
Troubleshooting Guide
Manufactured by Allmax International Corp. ,6F-2, No.186, Dadune 19th St., Taichung City, Taiwan
For products imported in the EU by Vendors/Sellers: Amazon EU SARL
