Model no
：
E-SM-1700-180-2H / ASIN no. B07V4CBHD7
NOTE:
DO NOT MOUNT ON THE GROUND, RECOMMENDED
INSTALLATION HEIGHT IS 6 ½ FEET TO 10 FEET
This product is intended for use with the enclosed gasket
and with a junction box marked for use in wet locations.
** Before you begin make sure that your power is turned off
at your circuit breaker box **
Do not rely on the switch power being turned off
Install the cross bar (E) to the junction box and secure with the
(2) mounting screws (I). If installing to a wall or building, pre-
drill holes and use appropriate plugs/anchors, once your holes
are drilled you can install the cross bar to the surface using the
two mounting screws (I).
1.
On the cross bar locate GND, attach the ground wire (G)
with the grounding Screw (F) to the cross bar.
2.
Connect supply wires with wire nuts (H) as shown in the
figure above.
Black supply wire connects to the Black power supply wire
(Live)
White product wire connects to the White supply wire
(Neutral)
3.
You may use the optional gasket (D) at this time.
4.
Install the light fixture (A) to the cross bar (E). Use silicon
sealant (not included) around the perimeter of the light to
seal for moisture.
5.
Screw in the stainless steel screw (C) to hold fixture in
place. Insert plastic screw cover (B) into screw hole.
6.
Turn on your electricity after the install has been
completed.
7.
Turn on power switch. (If power switch is not on, the light
will not cycle on or off)
Your light heads can be adjusted by turning the individual light
head to desired position. You can also adjust your light head
up and down to your desired position.
Your sensor head can be adjusted by turning the individual
light head to detection area. You can also adjust your sensor
head up and down to your detection distance.
For easy installation, select an existing light operated by a wall
switch for replacement.
For best performance, mount the fixture about 8 ft. (2.4 m)
above the ground.
NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming the
sensor down will reduce coverage distance.
CAUTION:
Keep the sensor at least 2” (51 mm)
away from the lamps.
SETTING THE MOTION SENSOR
( Detection Range: 50’ Detection Angle: 180°)
warning-risk of fire.Do not aim the bulbs at a combustible
surface within 3 ft.(1m)
350°
60°
60°
Adjusting Your Light Heads
Adjusting Your Motion Sensor
Installation
Motion Sensor Security Light
