- 8 -
3.3 Vacuum piping
(1) Before connecting the pipe to the pump, clean the inner walls of the vacuum chamber,
piping and vacuum valve to completely eliminate moisture, fine particles, dust, dirt and rust.
If fine particles, dust or dirt, etc are evacuated, the pump may malfunction.
If moisture is evacuated, not only does the ultimate pressure increase but
also the inside of the pump becomes rusty causing the pump to malfunction.
(2) Mount vacuum valve (A) and leak valve (B) between the vacuum chamber and pump as
shown in Fig. 5
Fig. 5 Basic piping diagram to the vacuum chamber
(3) Vacuum tubing between inlet port and another port is provided with vacuum rubber hose.
The wire mesh in the inlet port has been adopted to prevent foreign matter
from entering the pump. Do not remove the wire mesh.
Note
V
acuum c
ham
ber
Vacuum valve
(A)
Leak valve (B)
Pump
Note
