Ultrasonic Ultra 3200FA, Руководство по эксплуатации

Страница: 4 / 17

UltraSonic LLC. Model Ultra 3200FA
4

Make sure drain valves are closed and then add water and cleaning agent (typically
10% of approved soap per tank volume for general purpose cleaning) to the main
tank. When the main tank is full the water will cascade into the weir tank; continue
adding solution until the level in the overflow tank is 3” above the low water control
switch

Do Not Plug in Machine until unit is full of water and cleaning solution, doing so
may cause damage to your UltraSonic tank and Void warranty

Use only UltraSonic LLC approved cleaning agents and be sure you use the proper,
recommended concentrations (typically 10% of approved soap per tank volume for
general purpose cleaning).
•
Check your power supply before connecting unit. The system is designed to operate
on (220v-240V 1Ø Ultra 3200FA) Have certified electrician connect power supply.
The unit may require a Buck/Boost Transformer depending on incoming power.
Incoming Power above 240 volts will void Machine Warranty .

Flip rocker switch POWER ON/up button, Heater Control & Ultrasonic lights will
display green.

Operating temperature is pre-set @ 150°F on the TEMP CONTROL . Initial heat-up
time using cold water is approximately two hours. For automatic heating see
Programmer – Heat

When operating temperature of 150°F is reached, set Ultrasonic Timer to 15 minutes
and push green Cycle start button. This process, known as degassing, will remove air
from the bath, which is required for effective cleaning. During this degassing phase
some squeaking sounds may occur, this is normal.

Unit is now ready to clean parts, see NORMAL OPERATION procedures.

Fill out WARRANTY REGISTRATION form, page 15 (serial # plate located on
back panel of unit) and send back to UltraSonic LLC to ensure activation of your
warranty.