Ultrasonic Ultra 3200FA, Руководство по эксплуатации

Страница: 3 / 17

UltraSonic LLC. Model Ultra 3200FA
3

Do not open up machine, dissemble any part(s), move or remove any components or
electrical devices.

Do not connect the equipment to any other power supply than what is specified.
(220v-240V 1Ø Ultra 3200FA)

Do Not Plug in Machine until unit is full of water and cleaning solution, doing so
may cause damage to your UltraSonic tank and Void warranty

The generators contain high voltages and should be maintained in a clean, dry
environment at all times.

Do not move the cleaning system without draining the tank and disconnecting the unit
from the power supply.

Operating temperatures of the solution requires protective clothing and equipment to
protect against the possibility of scalds following accidental spills.

Make sure that the sound levels experienced in your environment are known, and
wear hearing protection if necessary. Ultrasonic energy produced by the system is
measurable by sound meters and OSHA sound restrictions may apply.

Do not leave the ultrasound on or leave parts in the tank longer than necessary. This
can result in erosion of the part surface and/or the bottom of the tank.

Do not allow moisture to build up inside the unit, this can cause electrical shorts and
corrosion of the ultrasonic transducers.
INSTALLATION & INITIAL SETUP

Receiving- Inspect packaging and unit carefully to ensure there has been no damage
in shipping.
If there is damage, contact the carrier immediately to process a
claim .

Place the unit in a well-ventilated area on a flat level surface.

Remove cover in back of machine to access filter canister using the special tool to
loosen and remove canister. Insert filter element into the canister. Insert filter
element into the canister. Carefully reattach canister to housing (be careful not to
damage O-rings), hand tighten the canister in place to ensure a tight fit, use special
tool to snug canister, do not over tighten.