CAMERA CONNECTIONS
1. Connect the VIDEO output of the camera to the video
input of a monitor or other equipment.
When using a “loop through” connection of two or
more monitors, set the 75
switch of only the final
monitor to ON.
2. Determine the type of cable according to the distance
of the connected equipment.
3. Do not turn any component’s power on until all
connections are completed.
- 16 -
- 17 -
If you experience diffculties operating your camera, refer to the following. If the
guidelines do not enable you to solve problem, contact an authorized
technician.
TROUBLESHOOTING
SECTION 3:
TROUBLESHOOTING AND MAINTENANCE
Nothing appears on the screen
Are the power cord and line
connection beween the camera
and monitor made properly?
Is the DC/Video selection switch
on the back of the camera set
properly accordng to the type of
auto iris lens?
The image on the screen is dark.
Is the Shutter feature set to the
ESC mode?
Are the sensitivity and brightness
levels set properly in the Shutter
feature?
The afterimage of the moving
This is a normal situation that occurs
objects remains on the screen.
temporarily when the camera
converges available light to produce
a clear image under low illumination.
Decreasing the Shutter sensitivity
level can eliminate it, but the image
on the screen may be darker.
The image on the screen is dim.
Is the lens dirty? If so, clean the lens
with a soft, clean cloth.
The camera is not working
Is the camera connected to the
properly and the surface of the
proper power?
camera case is hot.
PROBLEM CHECK
Continued on next page.
Power Source
(24Vac or 12Vdc)
To Video input connector
Video type lens
(or galvanometric type lens)
To Lens connector
To Power input terminal
