ULTRAFRYER Systems Ultrastat 11, Руководство по эксплуатации

Страница: 6 / 29

B. SAFETY: The Model S5420212 Automatic Basket Lift System operates on 120 Volts, 60HZ, single phase electrical power, and like
other electrical equipment, should not be operated with wet hands or while standing in water. Water should
NEVER be sprayed on
or at the rear of the Basket Lift System as there is danger of electrical shock and/or serious damage to the system electrical circuitry.
The Basket Lift System is located in close proximity to
HOT shortening and care must be taken to avoid serious burns from acci-
dental shortening splatters. The floors in front and behind the fryer should be kept clean and dry.
C. SAFE CLEANING PROCEDURES: Before performing any cleaning routine, electrical power to the Basket Lift system MUST be
removed by disconnecting the fryer’s 120 Volt electrical plug from the 120 Volt electrical receptacle. A dampened cloth with sanitizer
solution may then be used to clean debris from the Basket Lift Arms, Rollers, Roller Guides and Basket Lift System.
D. MANUFACTURED BASKET LIFT COMPONNETS - Although the basket lift assembly is provided by SKF Motion Technologies,
Ultrafryer Systems, Inc. provides the necessary sub components to complete the system. These parts include:
1. Basket Lift Arms
2. Roller Guide Basket Bracket
3. 90˚ Angle Mounting Brackets
4. Modified Fryer Back Panel
These are identified in the Parts section of this manual.
E. DESCRIPTION / SPECIFICATIONS:
1. DESCRIPTION: The Model S5420212 Automatic Basket Lift system consists of an Electrical Control Box which contains the
following SKF Components:
1) One (1) 120-24 Volt Step-Down Transformer
2) Two (2) Printed Circuit Boards (PCB)
3) Two (2) 24 Volt DC Motors
4) Two (2) Gear Boxes
5) Two (2) Lifter Rods
In adition, there are Two (2) Electrical Cords, One (1) with a Three (3) pin male connector and One (1) with a Four(4) pin male
connector. The three (3) pin male connector connects to a three (3) pin female socket on the fryer which provides electrical
power to the Basket Lift system. The Four (4) pin male connector connects to a Four (4) pin female socket attached to the fryer
which interfaces with the fryer’s computer to control operation of the Basket Lift system. This Basket Lift system is applicable for
ALL three (3) currently produced vessel sizes; 14" (356mm), 18" (457mm) and 20" (508mm) Gas or Electric Ultrafryer Systems,
Inc. fryers.
������ ����
��������� �����������
������� ������ �����
�� �����
���� ���
Three (3) Pin
Male Power
Connector
Four (4) Pin
Male Computer
Interface Connector
Basket Lift System
Shown With Rear Panel
Removed
Page 3 of 26
30A081
2. SPECIFICATIONS: The Model S5420212 Automatic Basket Lift system, Manufactured by SKF
Motion Technologies, is 3 1/2" (89mm) deep, 14" (356mm) Wide and 23" (584mm) high and
operates on standard 120 Volt single phase 60 Hz electrical power.
NOTE: THE ULTRASTAT COOKING COMPUTER IS PROGRAMMED SO THAT THE
BASKET LIFT SYSTEM CAN ONLY BE OPERATED WHEN SHORTENING IS
AT ITS PRE-SET COOKING TEMPERATURE.
WARNING: DO NOT OPERATE THE BASKET LIFT WHEN A PRODUCT BASKET IS IN THE VAT BENEATH THE
BASKET HANGER PLATE