Owner’s Guide
Emergency Service Mode - (Valet)
This feature will disable the system except for locking and unlock functions.
This mode can also used if a remote is lost, damaged or if the system malfunctions.
ENTERING SERVICE MODE
1. Turn the ignition key to the “On” position then press and hold the Program
Button on
the antenna for 5 seconds or until the siren chirps
5
times.
EXITING SERVICE MODE
1. Turn the ignition key to the “On” position then press and hold the Program
Button for 5
seconds or until the siren chirps
2 times.
Note: Remote starter functions will be disabled and the LED will be “on” steady.
The door locks and the trunk release will still be operational.
Ignition
“On”
7 sec.
ATTENTION:
THE SYSTEM MUST BE PLACED INTO SERVICE MODE BEFORE ANY UNDER
HOOD SERVICING IS DONE TO THE VEHICLE. IT IS THE RESPONSIBILITY OF THE VEHICLE’S
OWNER TO INSURE THAT THIS IS DONE. THE MANUFACTURER ACCEPTS NO RESPONSIBILITY
FOR ACCIDENTAL STARTING WHILE VEHICLE IS BEING SERVICED.
The battery icon on the remote will indicate the present level of the transmitter battery. When the
transmitter indicates the battery is low it should be replaced. Replace with quality 1.5volt “AAA” battery.
Battery Replacement
1
Lift
Slide
+
-
System Service Mode(Valet) - By Remote
This feature will disable the system from the remote transmitter. Use this feature
must be used when having the vehicle serviced. ( Oil change, Tune-up etc.)
Note: Remote starter functions will be disabled and the LED will be “on”
steady. The door locks and the trunk release will still be operational.
ACTIVATE Service Mode (User Programmable Feature)
1 - Press and hold button #4 for 3 seconds. (The remote will beep twice)
2 - Press button #1 Five times or until the
?
starts flashing on the LCD screen.
3 - Press button#3 and the
?
symbol will come on solid.
4 - Press button #4 to exit User Program Mode.
(System Is Now In Service Mode)
5 - The siren will chirp once and the LED’s on the antenna will come on solid.
DEACTIVATE Service Mode
1 - Press and hold button #4 for 3 seconds. (The remote will beep twice)
2 - Press button #1 Five times or until the
?
starts flashing on the LCD screen.
3 - Press button #2 and the
?
symbol will turn off.
4 - Press button #4 to exit User Program Mode.
(Serice Mode is Deactivated)
5 - The siren will chirp once and the LED’s on the antenna will turn off.
