Owner’s Guide
1. Press and release Button #3 on the Remote Transmitter.
2. The Park lights will flash and the siren will chirp one time.
3. The remote will beep 3 times and the Key Icon will begin flashing.
4. When the vehicle has started, the system will flash the park lights four times and then remain “On”
while the vehicle is running.
5. The Runtime Bar Graph will appear on the LCD screen and begin counting down.
6. The vehicle will continue to run for the programmed runtime. (Normally 15 minutes).
Remote Start
Extended Run Time
Remote Stop
Idle Mode
Optional 4th Channel Activation
1. Press and hold Button #3 for three seconds. The remote starter will then shut down.
2. The park lights will flash and the siren will chirp two times.
3. The transmitter will beep to verify the status of the alarm. (Armed or Disarmed)
Note: Pressing the brake pedal or opening hood will also stop the vehicle.
1. Press and release Button #3 while the vehicle is running by the ignition key.
2. The park lights will turn on and the siren will chirp once.
3. The Remote will beep and the Run Time Bar Graph will light up.
4. Turn the ignition key “Off” and the vehicle will continue to run.
5. Exit the vehicle and leave it running safely without the keys in the ignition.
Note: Always lock the doors when leaving the vehicle unattended.
1. Press and hold buttons #3 and #4 together for two seconds.
2. The park lights will flash and the siren will chirp one time.
3. The 4th Channel output will activate as programmed by installer (Active, Pulsed or Latched)
Active - The output will stay activated as long as buttons #3 and #4 are held.
Pulsed - The output will respond will a single pulse when activated.
Latched - The output will stay activated until buttons #3 and #4 are pressed again.
Note: Turning the ignition On will deactivate the Latched output.
REMOTE STARTER FEATURES
1. Press and release
Button #3 while the vehicle is running by the remote starter.
2. The park lights will flash and the siren will chirp one time to confirm that the runtime has been
extended. The system will reset the run time, (Normally 15 minutes).
Note: The Runtime Bar Graph is not updated by the activation of Extended Runtime.
Reservation Mode (Manual Transmissions Only)
THE FOLLOWING STEPS MUST BE COMPLETED TO REMOTE START A MANUAL TRANSMISSION VEHICLE. 4
SLOW PARK-LIGHT FLASHES WILL OCCUR IF START BUTTON IS PRESSED AND SYSTEM IS NOT IN
RESERVATION MODE
1. While the vehicle is running, apply the Park Brake then press & release the Brake Pedal.
2. The park lights will flash to confirm that reservation mode has been activated.
3. Remove the key from ignition (The vehicle will continue to run) exit the vehicle and close the door.
4. The vehicle will shut off when the door is closed. (If the vehicle has a delay dome-light, it may
continue to run until the dome-light turns off)
5. The system is now in Reservation Mode and can be safely Remote Started.
Note: Opening the door after this point will cancel the Reservation Mode*.
*
To re-enter the vehicle without cancelling the Reservation Mode. Remote Start the vehicle and
unlock the door’s by the remote, (The unlock icon will appear) then open the door. When done, close
the door and press Button #1 on the remote (the system will arm) then press and hold button #3 for
three seconds (The vehicle will turn Off).
