8
3.2 Fan conveyor
Fig. 3.d
The air flow conveyor P# UP_P_0554 can be installed on the top of the
inlet air fan by (removing the protection grill) so air from a different
place can used entering humidifier chamber.
Ideal for tooling or machine in a sealed environment
3.3 Elbow connector
Fig. 3.e
The elbow connector P# UP_P_0555 can be installed on the top of the inet
air fan. Ideal if plastic hose is attached to minimize crimping hose.
3.4 Diffuser
Fig. 3.f
The diffuser P# UP_P_0556 can be installed on the cover, to deliver mist
directly into the room.
3.5 Filter: 50 micron
Fig. 3.g
The 50micron filter P# UP _P 0557 is available to be installed on inlet fan,
using the conveyor (with or without the elbow). It’s necessary to clean the
filter (with compressed air or running water) periodically: frequency depends
on the environment in which the system is installed. Features filter: 50 micron,
H = 5'', D = 2"
3.6 Example in tooling application
Fan coil installation example
Fig. 3.h
3.7 Duct installation example (UP01/UP02)
Duct installation example.
Fig. 3.i
Connect the optional fan conveyor P# UP_P_0554 on top of return fan
and connect optional plastic flexabe hose P# UP_P 0553-5 to the return
side of the duct. Connect out of humidifer with same hose to downstream
air.
Ultra Pure can supply fan conveyor (P# UP_P_0554 to create the
connections between duct and hose. The hoses should be as short and as
straight as possible (max 2' part), so as to reduce pressure drop.
If using P# UP_P_0553 distribution system in, turn the distributer so that
the holes are in the direction of air flow (see the figure)
Fig. 3.j
