UltimateAir 200DX, Руководство пользователя и инструкция по установке

Страница: 19 / 52

The UltimateAir® RecoupAerator® 200DX Manual and Installation Guide, March 2014
 


CAUTION
Before performing any service to your RecoupAerator, switch off the unit and
disconnect power from the unit. You must disconnect power by either
unplugging the unit or by switching the applicable breaker in your breaker box
to off. Otherwise, the main power to the unit will remain hot and could cause
serious bodily injury.
Basic Electrical Wiring
The RecoupAerator Model 200DX is supplied with two blower motors, one
energy recovery wheel drive motor, and a detached wall controller that can be
mounted near the unit or in a remote location. Follow all applicable electrical
codes.
The RecoupAerator can be wired in a number of different ways depending on
desired features. This section of the manual describes each benefit option and
shows the wiring procedure to accomplish them.
Factory Default Settings
Airflow. This unit contains two blower motors, each independently controlling
the airflow coming into the building (Blower 1, supply), and leaving the
building (Blower 2, exhaust). The unit has the capability of lowering the airflow
from the building going to the outside by a selectable set of offset jumpers on
the three-motor control board. Factory settings provide for “balanced”
airflow, that is, equal airflow both coming into the building and exiting the
building.
Input. The RecoupAerator comes equipped to handle several different types of
control input. From the factory, The RecoupAerator is wired with the North
American Wall Dial Control, unless otherwise specified at the time of order.
EconoCool. This unit comes with an economic ‘night’ flush feature. There is a
small silver toggle switch mounted next to the Main Power switch to turn
EconoCool ON and OFF. Please see the ‘econocool’ section in this manual for
further detail.