UltimateAir 200DX, Руководство пользователя и инструкция по установке

Страница: 34 / 52

The UltimateAir® RecoupAerator® 200DX Manual and Installation Guide, March 2014
 

Your RecoupAerator can be programmed into a “smart house” control, so that
it can be controlled remotely or using any 0-10 VDC control signal. To set up a
0-10 VDC input signal control system,
disconnect all power to the unit .
1. Set jumpers JMP1 to the EU position, and J3 to the 0-10V INPUT position
on the three-motor controller as shown in the drawing below to enable
the 0-10 VDC control input.
2. If a Wall Dial Control is attached to the unit, remove it. You do not need
a Wall Controller when operating the unit with a 0-10VDC input control
signal.
3.
Locate the two screw terminals labeled “0-10V CMD INPUT”, as shown
above, and connect the signal control wires to these posts as indicated.
Boost, EconoCool™, air flow offsets, and furnace input functions are still
operational when using the 0-10V input signals to control the unit. Review
following graph for the input VDC versus airflow relationship to help program
your control.