ULTIMATE SPEED ULGD 10 A1, Перевод оригинальной инструкции

Страница: 42 / 170

41 GB/IE
z
Disconnecting
Stop charging using the battery
clamps:
„
Disconnect the device from the
mains current.
„
Disconnect the “–” pole
quick-contact connection terminal
(black)
21
from the “–” pole of the
battery.
„
Disconnect the “+”-pole quick
contact-connection terminal (red)
19
rom the “+”-pole of the
battery.
„
Reconnect the plus pole connec-
tion cable of the battery to the
plus pole of the battery.
„
Reconnect the minus pole connec-
tion cable of the battery to the
minus pole of the battery.
Stop charging using loops:
„
Disconnect the device from the
mains current.
„
Pull out the plug, which connects
the output with the plug
15
with
the connecting cable with loops
17
.
„
Cover the contacts of the connect-
ing cable with loops
17
with the
attached cover cap of the connect-
ing cable with loops
16
.
z
Standby / Measuring
battery voltage
After connecting the mains supply,
the device is in standby mode. The
display is in use. When the connec-
tion terminals are connected, the
battery voltage is displayed on the
LC display (voltage display
11
). The
segments of the status display
10
are
empty. If the measured voltage is
below 2 V, then this means the
battery is not charging.
z
Battery recognition
If a battery with a voltage over 2 V
is connected, the charging process
will start once the charging program
is selected. Deeply discharged bat-
teries can also be charged, as long
as they are not defective.
If a battery with a voltage of over
15.6 V is connected, in 12 V mode,
“Err” will be shown in the voltage
display
11
. The charging process in
24 V mode.
If the charger is connected to a
battery with the poles reversed,
“POL” will be shown on the display.
The charging process will not be
activated.
z
Revival
After battery recognition, depend-
ing on the battery status, the revival
process will be activated. Pulsating
Using the device