Ultimaker S3, Инструкция по установке и эксплуатации

Страница: 5 / 33

Ultimaker S3 and Ultimaker S5 user manual 4
1.1 Safety messages
This guide contains warnings and safety notices.
The information provided below is applicable to the Ultimaker S3 and Ultimaker S5.
Provides additional information that is helpful to do a task or to avoid problems.
Warns of a situation that may cause material damage or injuries if the safety instructions are not followed.
1.2 General safety information
• Ultimaker 3D printers generate high temperatures and have hot moving parts that can cause injury. Never
reach inside Ultimaker 3D printer while they are in operation. Always control the printer with the touchscreen
at the front or the power switch at the back. Allow the Ultimaker 3D printers to cool down for 5 minutes
before reaching inside
• Do not change or adjust any parts of the products unless the change or adjustment is
authorized by the manufacturer
• Do not store items inside Ultimaker products
• Ultimaker products are not intended for use by persons with reduced physical and/or mental capabilities, or
lack of experience and knowledge, unless they are supervised or have been given instructions concerning the
use of the appliance by a person responsible for their safety
• Children should be under constant supervision when using Ultimaker products
1.3 Hazards
Electromagnetic compatibility (EMC)
These devices may not cause harmful interference, and these devices must accept any interference received,
including interference that may cause undesired operation.
An electrostatic discharge in some metallic parts of the devices may cause the interruption of the NFC
communications, affecting the initial detection of the material spool. In these cases, a device restart
should solve the problem
Electrical safety
Ultimaker products have been tested according to the IEC 60950-1 and/or IEC 62368-1. All relevant products
have undergone and passed hi‐pot testing before shipment. This test guarantees the right level of insulation
against electrical shock. An earthed mains socket must be used. Be sure that the building installation has
dedicated means for over-current and short-circuiting. For more information, please visit our website for the
CB-certificate. The Ultimaker 3D printers are powered by mains voltage, which is hazardous when touched.
Only trained staff should remove the bottom cover.
Always unplug Ultimaker products before performing maintenance or modifications.