ULS VLS Series, Руководство по обслуживанию

Страница: 36 / 82

VLS Service Manual - REV2015.04
Table of Contents
Component Removal and Replacement
Page | 36
Component Removal and Replacement
6. Open the rear cover by pulling the latches toward the back of the system or by pressing down on the
button part of the latches until the latches pop up.
7. Fold the Rear Cover down to its resting position.
8. Locate the top door hinges and remove the screws and washers holding them in place. Store them in a
safe location. Remove the hinges.
9. Installation is opposite of removal.
10. Plug in and power ON the VLS. Open and close the door. Check to see if the door open light on the
keypad turns on and off (red flashing light) when you open and close the door. Or check the UCP to see
if the system is indicating that a door is open.
4. Move the hydraulic pressure cylinder out of the way by gently laying it inside the system.
5. With another person holding the top door remove the four screws and washers that hold the top door in
place. Set the top door in a safe location and set the screws and washers safely aside.