UIC Bezel5 Programmer’s Manual
Page.31/166
UDN PM098 Rev. 1.0
Copyright © 2013, Uniform Industrial Corp. All Rights Reserved
3.3.3.
Self – Arm Mode
The default reader configuration is in “Self-Arm Mode”. This allows the payment cards (including
VISA MSD, ExpressPay card and the general magnetic stripe credit cards) reading functions to run
automatically, reporting the card data to the host without any instruction sent from the host.
With the reader running in the Self-Arm Mode, it can be configured to the “Host Polled Mode” by
disabling the Self-Arm Mode. The “Host Polled Mode” allows the card reading functions to be
controlled by the relevant host commands.
19B
Card Data Output for Different Types of Card and Reader Configurations
With the reader running in the Self-Arm mode and depending on the configuration set in the reader
and the type of card to be read, the reader will output different types of card information. The
following table lists out the summary of it:
Reader Configuration
Mifare Card Support
Type of Card
Disabled (MFxy = 10)
F
4
F
Enabled (MFxy = 11)
Payment Card
Track data
Track data
Mifare Standard 1K
N/A
“M2”
Mifare Standard 4K
N/A
“M3”
Mifare Ultralight
N/A
“M1”
Mifare Ultralight C
N/A
“M1”
Mifare DESFire
N/A
“M4”
Mifare Plus
N/A
“M5”
20B
Card Data Output in Self-Arm and Host-Polled modes
Sending card data under the Self-Arm mode:
Under the Self-Arm mode, the card data output will not include the protocol envelope code. The
user can insert the envelope code by utilizing the configuration commands
-
SE and TO
F
5
F
.
4
Please refer to 4.3.15. MFxy(4Dh 46h x y)
-
Set Payment Card and MIFARE Auto-Polling
5
Please refer to 4.3.20. SEx(53h 45h x)
-
Self-Arm Mode Data Envelope Enable/Disable
4.3.23. TOx(54h 4Fh x)
-
Set Transmitting Data Output Format