UFESA MP6815, Руководство по эксплуатации

Страница: 8 / 28

ENGLISH
IMPORTANT NOTES
• O
nly connect it to the voltage stated on the characteristics pla-
te.
• Read through these instructions carefully. Safeguard them for fu-
ture reference.
• Only use the appliance for the purposes described in this ma-
nual. Never use accessories not recommended by the manufactu-
rer.
• For additional protection, the installation of a residual current
device (RCD) having a rated residual operating current not excee-
ding 30 mA is advisable in the electrical circuit supplying the ba-
throom. Ask your installer for advice.
• The On/Off switch must be in the “0” position when plugging it
in or unplugging it.
• ATTENTION: Do not use the appliance near water contained in
baths, basins or other receptacles.
• Do not handle the appliance with wet hands, or with damp feet
or barefoot.
• Do not use the appliance on completely soaked hair.
• Always make sure that the accessories are completely dry (both
inside and out) before attempting to attach them to the styling
tongs.
• NEVER IMMERSE THE APPLIANCE IN WATER OR ANY
OTHER LIQUID.
• WARNING: Do not use this appliance near bathtubs,
showers, basins or other vessels containing water.
• When the hairdryer is used in a bathroom, unplug it after use
since the proximity of water presents a hazard even when the hair-
dryer is switched off.
• Do not operate the appliance with the cable still coiled.
• When using accessories: Curling tong and retractable bristle
brush, the barrel will heat up during use. Do not let it come into
contact with the skin.
• Check the inlet grille periodically to make sure that it has not beco-
me blocked with hair or fluff. Never block the air inlet grille.
• Do not leave the appliance operating unattended, especially
near children or the handicapped.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
• Never unplug it by tugging on the mains cable.
• Before cleaning it, make sure that the appliance is unplugged
and cold.
• Do not place or store the appliance where there is a risk of it
falling.
• Wait until the appliance is cold before storing it away.
• Do not switch the appliance on if the cable or the plug are da-
maged or if it can be detected that the appliance is not working
correctly
• Keep packaging material, such as plastic bags, out of children’s
reach.
• If the supply cord is damaged, it must be replaced by the ma-
nufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
• Cable repairs and replacements must be carried out exclusively
by an Authorised Technical Service Centre.
OVERHEATING SAFETY DEVICE
The styling tongs have an automatic cut-out device which discon-
nects it if the air intake becomes obstructed accidentally. Remove
the obstruction, switch it to “0” and wait for 5 minutes before swit-
ching it back on.
TIPS PRIOR TO SWITCHING THE APPLIANCE ON
- Always change the styling tong accessories with the appliance
switched off and unplugged.
- Brush and comb the hair so that it is untangled and loose before
using the styling tongs.
- The styling tongs are more effective when the hair is slightly
damp. If your hair is dry then dampen it slightly. DO NOT USE THE
APPLIANCE ON COMPLETELY SOAKED HAIR!
- Do a curl test to determine how long the curling accessory will
have to be left on the hair to produce good results. We advise
starting off at about 8 to 10 seconds.
If you want heavier curls then leave the tongs on the hair for longer.
Less time for lighter curls.
USE
Always plug the appliance into the mains when in the “0” position.
Then choose the desired heat setting on the power selector.
The Cold Air position reduces the temperature considerably and
allows it to cool down rapidly after styling.
For ease of use and greater mobility the Cold Air button is dual
function:
In the (•) position the Cold Air function will remain on permanently.
In the (P) position Cold Air will only be produced while the button
is being pressed. (Fig. 1)
Warning:
Check that the Cold Air switch is in the (P) position whe-
never you wish to use hot air.
Operating position:
0 The appliance is off
1 Power at 700 W with limited air flow
2 Power at 1000 W with maximum air flow
Push-button continuous Cold Air option
1 700 W 350 W
2 1000 W 500 W
A handy hang ring allows the appliance to be hung up on the wall,
simplifying storage.
CONTINUOUS IONISATION
This hairdryer is equipped with a system to generate negative ions
and which starts to work as soon as you switch the hairdryer on
and for as long as it is being used.
The action of the negative ions reduces the size of the water drop-
lets to make drying easier and allowing the hair to absorb much
more water. This produces softer, shiner, hydrated hair that is much
easier to comb. (Fig. 2)
ATTACHING & REPLACING ACCESSORIES
- To attach an accessory to the main body, line up the (

) mark
on the accessory with the ( ) mark on the main body and turn
it in a clockwise direction so that the (

) and ( ) marks line up.
You should hear it click into position. (fig 4).
- To remove an accessory, press the “lock accessory button” and
turn the accessory in an anti-clockwise direction until it comes off.
(fig. 5).