uebe Visomat double comfort, Инструкция по эксплуатации, Страница: 31 / 91

C
EN-60 EN-61
C Operating the unit Operating the unit
english
english
• Lay your extended and relaxed arm with the cuff on the dining table and do
not move it during the measurement; do not talk. The palm should be facing
upwards.
• Connect the cuff connector to the cuff socket on the left-hand side of the unit.
Make sure the connector is fully inserted into the unit.
8. Measuring blood pressure
The unit is designed for two users and has two Start/Stop buttons: User 1 presses
Start/Stop button 1 for measurement, User 2 uses Start/Stop button 2. The values
of the two users are saved separately and can also be evaluated separately.
You can also use the two user memories for separate evaluation of morning and
evening measurements. To do so, use Start/Stop button 1 in the mornings and
Start/Stop button 2 in the evenings.
• Switch on the unit by pressing the Start/Stop button. The
following display appears. Fig. 1
• The automatically controlled inflating process begins
once the unit has completed its calibration against the
ambient air pressure.
• The actual measurement takes place with the start of
deflation. The “
♥
” symbol in the display flashes until
the pulse frequency is displayed. Fig. 3
• The determined values of systole, diastole and pulse
and the pulse pressure (PP) (see Page EN-63) are
shown in alternating sequence in the display. Fig. 4
• The unit switches off automatically after about 3
minutes.
• A long beep signals the end of measurement, and the
cuff automatically deflates.
Fig. 3
Fig. 4
Fig. 1
If there is inteference noise during measurement due to
movements, the microphone integrated in the cuff cannot
record the Korotkow noise of the bloodstream properly.
In this case, the measured values are obtained using the
oscillometric method (see Page EN-48). After the meas-
ured values have been displayed, error message Err-4
appears. In this case, please check that the cuff and the
microphone are correctly fitted, then repeat the measure-
ment.
If error message Err-4 keeps appearing during every
measurement (Fig. 5), the microphone or the connecting
cable may be faulty. In this event, please contact visomat
®
Customer Service. For further failure and error messages,
see Page EN-80.
Fig. 5 Fig. 2
• The number of storage locations already taken up is dis-
played during the inflation process. In Figure 2 the latest
measurement is displayed with No. 01 and the taken-up
storage locations with 55. This display indicates when
the maximum number of 60 storage locations is taken
up and thereby old measurements are overwritten by
new ones. This helps you to identify the current take-up
status of the measured value memory.