uebe Domotherm E, Инструкция по эксплуатации

Страница: 9 / 15

EN-16 EN-17
Operating the device Operating the device
To retrieve the stored measured values, proceed as follows:
• With the device switched off, press the MEMO
button. The device switches to memory mode
(Figure 1)
• The most recent measured value no. 1 is now
shown (Figure 2). The measured value is alter-
nately shown on the display with the year (Figure
3), month/day (Figure 4) and time (Figure 5).
• Press the MEMO button repeatedly to open older
measurements (no. 2, no. 3, and so on).
If no measured values are saved, the following ap-
pears on the display (Figure 6):
• Open any stored measured value.
• Press and hold the START button for at least five seconds.
• The display first shows CL (Clear), then the memory number 0 (Fig-
ure 6).
Figure 6
Figure 5 Figure 4 Figure 3 Figure 2
Deleting the measured value memory
The device switches off automatically after 30 seconds. You can also
switch off the device before this by pressing the on/off button.
The device is equipped with a CR2032 lithium battery.
If the battery icon flashes on the display while the thermometer is
in use, the battery is low. Although you are still able to take tempera-
ture measurements, you should have a spare battery ready.
Replacing the battery
Figure 1
Change the battery if:
– After switching on the device, the “flat battery”
indicator (Figure 1) appears on the display. You
must insert a new battery before you can take
any temperature measurements.
– If nothing is shown on the display despite press-
ing the on/off button.
To open and close the battery compartment cover,
use the rounded side of the protective cap (see Fig-
ure 2).
Figure 1
Figure 2
• Unlock the cover on the battery compartment and
lift it off.
The thermometer has a measured value memory that can store 12
measured values. The measured values are automatically saved to-
gether with the date and time of the measurement. The last meas-
ured value is stored in memory location 1, the value measured prior
to that is stored in memory location 2, and so on. If more than 12
measurements are taken, the oldest value (no. 12) is deleted so that
the latest value (no. 1) can be saved.
Retrieving saved readings