8
9
Calibration Instruction
Please follow below steps to calibrate the drone if the drone becomes
imbalance after crashing during the flight, and can not be adjusted by trim
button and cause difficult operation.
1. Turn off the drone switch and then turn off the transmitter power switch.
2. Turn on the transmitter switch, push the Throttle Stick all the way up then all
the way down (Picture 15 and Picture 16), and the transmitter enters pairing
mode.
Picture 15
Picture 16
3. Power on the drone and put it on a flat surface in a horizontal position. You
will hear “di, do, di” beeping noise three seconds later, which indicates
successful code pairing. The drone body light will turn solid.
Picture 13
Picture 14
1. Turn on the transmitter switch and its indicator light begins to flash quickly.
Push the Throttle Stick all the way up, then all the way down. The indicator
becomes flash slowly, which indicates the transmitter enters code pairing.
2. Install the battery to the mounted box and power on the drone.
3. Put the drone on the flat surface, the indicator light of the drone turns from
flashing to stable bright. The drone is ready to be controlled.
Frequency Pairing:
Important Notice: Please make sure the gyro of the receiving board is placed on
the horizontal position after powering on the drone, so that the
drone is ready for controlling.
Pre-Flight Operation:
1. The camera is front.
2. Power on the drone and check the direction of the rotating blades. The left
front and right rear A blades rotating clockwise while the right front and left
rear B blades rotating counterclockwise.
3. Adjust relative transmitter Trim button to adjust the rudder if the drone tilts to
one side when flying.
Picture 18
Front
Left
Right
Rear
A Blade
Clockwise
B Blade
Counterclockwise
B Blade
Counterclockwise
A Blade
Clockwise
4. Do not move the Throttle Stick before successful calibration. Push the
Forward/Backward/Left/Right Stick as shown below (See Picture 17). The
drone body light flashes, which indicates that the drone is calibrating. When
the drone body light remains solid, your drone is ready to fly.
Picture 17
Flying Control by Transmitter
1. Push the Throttle Stick up to fly the drone up,
and pull the Stick down to fly the drone down.
2. Push the Forward/Backward/Left/Right Stick to
the left to fly the drone to the left, and pull the
Stick to the right to fly the drone to ther right.
