5. GENERAL CONFIGURATION
To complete the zone configuration two parameters must be configured:
A•
B•
Caution!
Choose the input audio source for every audio output. Use the SOURCE UP
and SOURCE DOWN and then press the "ENTER" button.
Choose whether you prefer the MIC1 to mute the rest of the audio sources
(highest priority) or to be mixed with them (no priority). In order to enable the
priority you must activated the “PRIORITY” switch and LED MIC1 will switch on.
The matrix includes an internal speaker to help you out while selecting the
assignment of the inputs to each output. To do so you may use the MONITOR
panel. You can listen to all inputs by pressing the ZONE SELECT button and
then ENTER. You can also adjust the speaker's gain by using the knob.
In case any of the zones has a remote control panel enabled, the zone
configuration will be disabled from the matrix. It must be done from the remote
control panel itself.
6. AUDIO EQUALIZATION
1.
2.
3.
4.
5.
The MX-800 matrix provides several gain adjustments for audio inputs and outputs. Therefore, the following steps
must be verified:
Adjust the gain control of every line input.
Adjust the gain control of all paging desks MX-801 from their rear panel as well as from the matrix's rear
panel.
Adjust gain and equalization ( bass and treble) of the different audio outputs (zones).
Adjust all gain controls from the front panel ( MIC1, MUSIC and MASTER).
In case there are remote control panels connected to the matrix, the gain control of the local sources as
well as the master gain control must be adjust form the same remote control panel by using the provided
knobs: Master level (“Source level”), local sources (“Music level”) and local microphone ( “MIC”).
SYSTEM CONFIGURATION
MX-800
SOURCE UP
SOURCE DOWN
PAGE BUSY
MIC1
PRIORITY
ZONE SELECT
OUTPUT LEVEL
FUNCTION
ENTER
BGM ALL
PAGE ALL
EMERGENCY
ESC
MONITOR
2
3
4
5
0
1
6
7
8
10
9
ZONE
12
12
610.387A
rev.
2
