NINA-B50 series - Hardware integration manual
UBX-22021116 - R02
Regulatory compliance
Page 46 of 57
C1-Public
This means the customer has to either market the end product under a Suppliers Declaration of
Conformity (SDoC) or to certify the product using an accredited test lab.
6.4.6.2
Co-location (simultaneous transmission)
If the module is to be co-located with another transmitter, additional measurements for simultaneous
transmission is required. The results must be added to the grant file as a Class II Permissive Change.
6.4.6.3
Adding a new antenna for authorization
If the authorized antennas and/or antenna trace design cannot be used, the new antenna and/or
antenna trace designs must be added to the grant file. This is done by a Class I Permissive Change or
a Class II Permissive Change, depending on the specific antenna and antenna trace design.
•
Antennas of the same type and with less or same gain as an already approved antenna can be
added under a Class I Permissive Change.
•
Antenna trace designs deviating from the u-blox reference design and new antenna types are
added under a Class II Permissive Change.
⚠
Integrators who want to refer to the u-blox FCC ID / IC certification ID should
contact
their local
support team to discuss the Permissive Change Process. Class II Permissive Changes will be
subject to NRE costs.
6.5
Japan radio equipment compliance
⚠
Approvals are pending for NINA-B501 and NINA-B506.
6.5.1
Compliance statement
NINA-B50 series modules comply with the Japanese Technical Regulation Conformity Certification of
Specified Radio Equipment (ordinance of MPT N°. 37, 1981), Article 2, Paragraph 1:
Item 19 "2.4 GHz band wide band low power data communication system".
6.5.2
End product labelling requirement
End products based on NINA-B50 series modules and targeted for distribution in Japan must be
affixed with a label with the “Giteki” marking, as shown in
. The marking must be visible for
inspection.
xxx-yyyyyy
Figure 19: Giteki
“
R
”
mark and NINA-B50 MIC certification number
6.5.3
End product user manual requirement
As the MIC ID is not included on the NINA-B50 marking, the end product manufacturer must include
a copy of the NINA-B50 Japan Radio Certificate in the end product technical documentation.
