Ublox C099-F9P-0-03, Руководство пользователя

Страница: 32 / 40

C099-F9P - User guide
UBX-18063024 - R12 Appendix Page 32 of 40
Appendix
A
Glossary
Abbreviation Definition
CLI Command line interface
FW Firmware
LiPo Lithium polymer
NTRIP Networked transport of RTCM via internet protocol
NVDS Non-volatile data storage
RTK Real time kinematic
UART Universal asynchronous receiver transmitter
UDP User datagram protocol
USB Universal serial bus
UTC Coordinated universal time
VCP Virtual COM port
Wi-Fi AP Wi-Fi access point
Wi-Fi STA Wi-Fi station
Table 3: Explanation of the abbreviations and terms used
B C099-F9P antenna specification
B.1 Wi-Fi/Bluetooth antenna specification
EX-IT WLAN RPSMA / Ex-IT WLAN SMA
Manufacturer ProAnt
Type ½ wave dipole dual-band antenna
Polarization Vertical
Gain +3 dBi
Impedance 50 Ω
Size 107 mm (straight)
Type Monopole
Connector
•
Reverse polarity SMA plug (inner thread and pin receptacle)
•
SMA plug (inner thread and pin)
Comment To be mounted on the U.FL to SMA or reverse polarity SMA adapter cable
Approval FCC, IC, RED, MIC, NCC, KCC*, ANATEL, and ICASA
Table 4: Wi-Fi/Bluetooth antenna
☞
The variant included in the the C099-F9P kit is with an SMA connector and has to be mounted on
the corresponding antenna connector of the C099-F9P board if you wish to use Wi-Fi or Bluetooth
connectivity.
C ODIN-W2 firmware upload via JTAG
ODIN-W2 firmware upload is possible through the 10-pin JTAG connector by using the STM Link
Utility SW and ST LINK V2 debugger device. STM Link Utility software can be found on
https://www.st.com/en/development-tools/stsw-link004.html
Check the availability of ST LINK V2 debugger device with local STM distributors.